Blade balancing is crucial to all aspects of helicopter flight, and to dial in your blades properly, this balancer will help you get them setup for flight. Use this simple Align blade balancer to properly balance your blades for the best performance possible.

Illustration depicts how to use this balancer; clear boxes that balancer is resting on are not included.

● Rod x1
● Nut x2

 

Current Reviews: 5

Submited By: Michal on 01/25/2009 It's a pretty simple device, but does the job nicely. Sometimes it's a bit difficul to tighten up by hand, but works great combined with a set of pliers.

Submited By: Ron on 09/08/2008 Simple and works well!

Submited By: samuel on 06/16/2008 Belle finition, parfait pour l'équilibrage des pales de Trex 450 !!! A ce prix, pourquoi se passer de cet accessoire? -Franchement, je ne vois pas-

Submited By: tyler on 12/04/2006 this works great with t-rex blades, and other simalar sized ones :)

Submited By: Nathan Weisbeck on 01/11/2006 Be aware that this balancer will NOT work for the HB CP2 or Blade CP. The shaft diameter is too big to fit the blades. Other than that, it is a nice little peice for the price and I'm sure it would work fine with other blades.

Write Review

Average Customer Rating: Displaying 5 of 5 product reviews

Current Discussion 1

Submitter By Alexander (Date Added: Tuesday 15 September, 2009)

Is this ok for Trex 500 blades?   Not Logged In

Your Discussion * Required information   E-Mail Address:  * Password:  *   NOTE: HTML is not translated!

Displaying 1 of 1 product reviews