Product Details
IMPORTANT INFORMATION REGARDING BEC's BUILT INTO ESC's - click here to view
The new Century Electron Brushless ESC's come easy to program with 4 flying modes. Just throttle up before plugging in your battery to enter programming mode, then throttle down upon selecting a mode indicated by the number of beeps (1 beep = mode 1, 2 beeps = mode 2, etc...)
Disconnect the battery, wait a few seconds, plug in the battery and start flying. The ESC features governor mode and non-governor mode for helicopters and airplanes. Soft-start when throttle has been in down position for longer than 15 seconds.
Features:
- Now includes Ferrite Ring!
- Easy to Use: 4 Flying Modes
- Supports Quick Throttle Response
- Supports Linear Throttle Output
- Supports Stable RPM Control
- Supports Compatibility with Most Brushless Motors
- Supports High Speed Brushless Motor
- 2-Pole Brushless Motors up to 240,000rpm
- 6-Pole Brushless Motor up to 80,000rpm
- 12-Pole Brushless Motor up to 40,000rpm
- Built-in Heat Sink
- Built-in Throttle Calibration Function
- Built-in Soft Start Function for Helicopter
- Built-in Governor Function for Helicopter
- Built-in Auto Motor Timing Function
- Built-in World Famous Brand MOSFET with High Quality, Reliability & Low Impedance
- Two Stage Protection Soft Cut then Hard Cut
- Low Battery Protection for LiPo/LiOn Battery
- High Temperature Protection for ESC Body
- PWM Frequency............................. 12Khz
- BEC Continuous Output................ None
- Continuous / 15-Sec Peak Current... 80A / 100A
- Maximum Operation Voltage / Li-Po Cell... 25V / 6-Cell
- Physical hardware limitation 30V
(If CNE480 utilizes anything beyond 6 cell Li-Po or 25V, the power source may cause serious damage to the ESC and will not be covered under warranty)
Low Battery Protection:
- Soft Cut Voltage....... 2.9V per Li-Po Cell
- Hard Cut Voltage..... 2.6V per Li-Po Cell
High Temperature Protection:
- Soft Cut Temperature..... 110°C / 230°F
- Hard Cut Temperature... 120°C / 248°F
- Weight: 83.96g
- Body Dimensions: 80mm x 30mm x 14mm
- Wire Length: 142mm
- Servo Lead Wire: 255mm
Click here for the instruction manual.
