Product Details
Designed for use with the ATG, Solid G, ect. Makes for an easy and
quick setup, allows access to hidden menus for extra fine tuning of
your ATG, Solid G, Ect.
- Plug in the G-view and turn on the radio.
- Hold down the "P" button for 6
seconds. This brings you into initial setup mode. You do not need to
change this if you have already gone through the initial setup in the
manual.
- Now hold down the "P" button again
for 6 seconds. This brings you to the Model Type. Do not need to
change this, although for the 600N make sure you are set on T-rex600.
It will flash the model setting quickly when you enter this mode then
switch to asking you if you want to switch it to a Vibe.
- Now push and hold "P" for 6 seconds
to enter the Pirouette menu. Now you want to change the default
settings in this menu as listed above. Scroll to each parameter by
pushing the "P" button briefly and releasing. Then use the "L" and
"H" buttons to decrease and increase the value. Once you are done
making the changes to the Parameter menu push and hold "P" for 6
seconds to move to the next menu (Response menu)
- Make the needed changes in the
Response menu (see list above) then push and hold "P" for 6 seconds to
move on to Parameter menu.
- Make the one change in the Parameter menu as listed above. Then turn off the radio.
- The gyro is now ready to fly.
The Solid-G gyro was designed to be
used with the G-view. In our opinion, the G-View is a must, but NOT a
necessity! The gyro will work PERFECTLY without it.They are not
packaged together as a set because once you purchase 1 G-View you do
not need to buy any more. Even if you have 5 ATGs and 5 Solid-Gs you
only need 1 G-view.
