Free Super Saver Shipping Eligible Learn More

JLog 2.6 GW

4 1
You will earn 70 points for buying this product

Availability: In Stock

As low as $6.48/mo with Affirm Learn More
Write a review earn 100 points



New JLOG2.6 including interface to support additional sensors including CV16 battery cell monitor!

This is the same as the Full JLOG2.6, but without the logging capability.

The JLog2.6 has added support for the KOSMIK as well as all the interfaces from the JLog2 including the Futaba S.BUS2 interface (JSend), an easy to use interface to a Castle Creations ESC, SPEKTRUM, HiTec (JCC), and a native SPEKTRUM TM1000. Some Highlights of the specs: 4x JR 3-pin 2.5mm, two of them equivalent to JLog2′s “K4″ and “K5″ (to a JIVE), a 3rd JR 3-pin replacing the “COM” of JLog2, and the fourth 3-pin JR is the Futaba S.BUS2 connector. The female on the JR side is to connect to a KOSMIK (the cable will be provided with JLog2.6), the connector on the opposite side is for a native X-Bus cable (sold by Horizon) connecting a SPEKTRUM TM1000.
  • connections for additional JLog-own sensors:
    • analog temperature sensor or
    • up to 5 digital temperature sensors or
    • RPM sensor or
    • up to 2 alarm lines, also pulsed for LEDs/Luxeons, Morse
    • (With a simple D.I.Y. adapter also temperature sensor(s) and RPM sensor may be connected at the same time, or one type of sensor and an alarm line.)
    o live data or telemetry       
    o 9 instead of 4 alarm types before (v.2.7)
    o motor current calculation now more granular at all and more exact in border areas
    o floating offset for calibration of values for motor and BEC current
    o temperature compensation of the motor shunt in the JIVE as well as re-calibration possibility
    o calculation of cumulative mAh more precise once again
    o now 31 in place of before 13 (respectively 18 with v.2.7) log values in LogView
    o alternative to configure the logger also without a PC (JLC) by a JETIbox orUnidisplay
    o besides telemetry also “wired” live data for setup purposes, with the displays JETIbox, SM Unidisplay or Graupner SmartBox
    o updating the logger is no more individualized and done by a file on the mSD
    o Further JLog-own sensors using special firmware (matrix), speed measurement with a pitot head and GPS, Robbe BID Chip, voltage, servo pulse lengths, etc. JLog can also serve as a phase sensor for a governor. Most connections are shown on the picture.