Comes with set screws to hold better.

9T
2.3mm bore shaft size
Module 0.5M

Current Reviews: 4

Submited By: Zaw on 03/02/2008 Bought one of those and installed on Brush less upgraded CP2 with stock main gear, tenth on this pinion ground up in first a few test flight, plasitc main gear on my CP2 is still good and nows its copper coated. Plastic 1 Copper gearing 0

Submited By: David on 11/22/2007 I received this pinion without set screw. Quality seems ok, but is not the same product as the photo.

Submited By: Alan on 03/07/2007 The threading on this literally stripped on the first turn in. loctite would fix it but I like to switch motors frequently for testing.

Submited By: Eric on 02/13/2007 I had a similar experience as another reviewer in that the set screw can strip out easily. However, using loctite can make the set screw stay put, and using loctite on the motor shaft will keep the pinion very firmly in place. -- ET -- http://www.etheli.com

Write Review

Average Customer Rating: Displaying 4 of 4 product reviews

There are currently no discussion.

Your Discussion * Required information   E-Mail Address:  * Password:  *   NOTE: HTML is not translated!

Displaying 0 of 0 Discussion