Free Super Saver Shipping Eligible Learn More

RJX CAOS 210 FPV Racing Quadcopter- BnF to Futaba FASST Transmitter

0 0
SKU: EDN-1678
You will earn 342 points for buying this product

Availability: In Stock

As low as $31.68/mo with Affirm Learn More
Write a review earn 100 points




Line link:C210C

 RJX CAOS 210  FPV Racing Quadcopter-Combo

Installed on your battery, take out your radio , you can fly it

The CAOS 210 Quadcopter airframe is a small yet fully functional FPV quad deserving the QAV label. The Caos 210 is a symmetric 215mm size airframe that accommodates 5" props. The 215mm is measured motor shaft to motor shaft diagonally.


1.Provide a full range of motor protection design

2.Plastic mount the camera can slow impact

3.Framework designed to provide sufficient flight and collision strength。

4.The center of gravity and the propeller of the pneumatic center coincide

5.Using high quality Quick assembling and dismantling nylon fence (Prevent water from splashing and protective equipment)


Weight: 380g without battery 

Power Requirement: 4S 1300-1500 mAH

ESC:4S 15A-20A

Motor size: 2204-2406

Props:5" RJX Props

Camera:Aomway 700TVL

Receiver Compatibility: CPPM, S-Bus, Spektrum™, XBus, SumH, SumD (no external adapters required)

Flight Time: Highly dependent upon battery, and flying style

Included in the box:


Q3003CWx2  RJX Brushless Motor (2204 2300kv 2mm Plug CW)

Q3003CCWx2 RJX Brushless Motor (2204 2300kv 2mm Plug CCW)


Q3014 RJX TS5823

Q3096 RJX4-S.BUS mini Receiver 2.4G Receiver FASST Compatible


Q3087 RJX Buzzer TMB12A05

Q3084 RJX NAZE32 SP Racing F3 ACRO

Q3085 RJX Damping for NAZE32 CC3D Racing F3

Q3093 RJX Camera Mount For Aomway

Q3116 RJX 5.8G Antenna X2 (Internal thread hole, can be bend stereotypes)

T6011-YXS RJX Battrey Strap(200X20mmx2pcs)Lime Yellow for FPV Racing

Q3111 RJX CMOS MINI Camera 5V 25x17mm 2.1mm 1/2.7" 3MP Large glass mirror

Require to fly:

1.Radio Transmitter

2.Battery: 4S 1300-1500mAh


Output mode setting(only available on FASST air system):

Turn off the transmitter,connect the battery to the receiver,you will see the Red LED light

flashing.The RED LED flash high speed to indicate receiver is in special output mode OR

Low speed indicate receiver is under (LS)low speed PPM normal output mode,press the

F/S button for 5-6 seconds while the Green LED is off,(RX in sigal searching status),then release the button.You will see the Green LED will flash for about 4-5seconds .(NOTE:The Green LED will FLASH high speed under special mode OR FLASH low speed under normal output mode).lf you press the F/S button a second time while the Green LED is flashing,the receiver will change its output mode status (special/normal),if you not press the F/S button.Output mode will not be changed and the Red LED will flash at its original speed.

 Note:Output mode function is described in the form below,




Ch1~Ch4 independent(LS)PPM output


Chi~Ch6 independent PPMOutput


CH7 S.SBUS output for compoct system


Ch1 Neg PPM out (Fuataba trainer FUNC)^1


CH1~CH6 independent high speed (HS)PPM out for helicopter fast response control

CH2 Pos CPPM out for special user^2

CH3 RSSI PWM out for fpv()^3

CH7 S.BUS output for compact system

CH4 S.BUS output for compact system




Additional Info

Now on sales N/A
Frame Size 200-280 Sized