The 5in1V3 has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB.
It is a 5in1 HUB with Power Distribution Board, BEC 5V/3A &12V/500mA, LED Light Controller, Lost Plane Finder & Low Voltage Alarm functions.
It is specially made for the Multi-Rotors, mini FPV Quad. Built-in 5V BEC can be connected to receiver or flight controller with Aux pins directly.
simplify wiring. The BEC 12V can be used to power the Camera, Video Transmitters,ect. Inbuilt 5V LED light controller, three flash modes can be
choosed with the toggle switch of transmiter. And the buzzer can also be triggered with the toggle switch, which can help you find the models in tall
grass or trees. the 5in1 also acts as a battery voltage monitor. Once voltage gets below the threshold you set, the buzzer & LED light will remind you.
Built-in 5 functions, small size & light weight
2oz copper & 4-layers PCB.
ESC & Battery solder tabs in pairs
BEC 5V & 12V Output LED indicators
TVS input protection
Input voltage range (3S-6S operation): 9 - 26VDC
1 Battery input & 4 ESC outputs
Regulated 5V and 12V outputs
LED power indicators ( 5V & 12V outputs )
4 pairs 5V LED light pads
Low voltage setting value indicators
- Dimensions: 46x36x6mm, Weight: 9g
- Mounting holes 30.5mm square spacing
Continuous current: 20A per output
Peak current (10 seconds/minute): 25A per output
Designed for RC Receivers, Flight controllers, OSD, and Servos.
DC/DC synchronous buck regulator, Efficiency is up to 95%.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 3 Amps
Short-circuit tolerant (10 seconds/minute)
5V is also on the Aux pins + & -.
If other 5V BEC in use, Pls remove the red wire on Aux pins.
Linear regulator, very low noise.
Standard output designed to power cameras and video transmitters,etc.
Voltage: 12.0 +/- 0.3VDC (4~6S operation)
Continuous current: [email protected] IN (Max.1A 10s/minute), [email protected] IN
|Now on sales||N/A|