BETAFPV has designed a case to fit the GoPro Lite Camera. If you already have has a GoPro HERO 6/7, this is the great choice to mount your GoPro and protected it from a crash. Lightweight and easy to use. Comes with a BEC board.
Note: This case and BEC board fit for GoPro Hero 6 and Hero 7 Black. But NOT for Hero 8.
- BEC Board is specially designed for Naked GoPro Hero which weighs about 1.5g, make your naked GoPro lighter and easier to install on your drone.
- The BEC output voltage is 5V@2A, avoid the accident of power off which is caused by the insufficient power supply for the FC board.
- Integrated GoPro stock buttons, Power/Mode Button and Record Button.
- Integrated GoPro stock LED to know the status of the camera.
- Pad is available for pilot to control the GoPro recording via the radio transmitter.
- With the pluggable connector, which is easier to connect with your flight controller for power supply and recording.
- Item: Case for GoPro Lite Camera
- Output: 5V@2A
- Voltage: 2-4S
- Connector: GH 1.25 3P Connector
How to Assemble
- Step 1: Assemble the BEC board on the GoPro motherboard and put the shim 1 and shim 2 to fill small gaps between them.
- Step 2: Hold the camera lens and the camera board at the same time, be careful when you assemble the board on the case.
- Step 3: Screw the GoPro motherboard with the M1.4*5 screws as shown below
- Step 4: Install the carbon fiberboard, and screw the board with M1.4*8 screws as shown below.
- Step 5: Install the camera lens holder as shown below and screw the camera lens with M1.4*12 screws.
- Step 6: Install the ND filter holder and camera board holder to make it done.
ND Filter Holder
This ND Filter Holder fits perfectly for the standard GoPro ND filter (Not included).
Parts of GoPro Lite Series
We know some of the pilots might have a question about how to get the case for the naked GoPro or some might wanna grab the GoPro Lite Camera directly. Here we provide some more choices for your better installation.
- Beta95X for GoPro Hero
- Beta85X for GoPro Hero
- BEC Board for GoPro Hero
- Case for GoPro Lite Camera
- GoPro Lite Camera
- 1 x BEC Board for GoPro Hero
- 1 x Case for GoPro Lite Camera
- 1 x GH1.25 Power Cable (80mm 30AWG)
- 2 x Shims to fill small gaps
- 1 x Pack of Screws