SAB Swash Leveler for Goblin 380

|
H0584-S
You will earn 21 points for buying this product
Price Match Guarantee
$21.00 $0.00( / )
H0584-S - Swash Leveler - Goblin 380 Use for setting Zero Pitch for the Goblin 380 Easy to use with out the need of remove Head system Includes : - Swash Leveler x 1pc Use for : - Goblin 380

H0584-S - Swash Leveler - Goblin 380

Use for setting Zero Pitch for the Goblin 380

Easy to use with out the need of remove Head system

Includes :

- Swash Leveler x 1pc

Use for :

- Goblin 380

Type: 

Helicopter Part

Vendor: 

SAB Heli Division

SKU: 

H0584-S

Weight: 

0.06 lb


Product Spare Parts


Electronics

Customer Reviews

Based on 8 reviews
63%
(5)
0%
(0)
0%
(0)
38%
(3)
0%
(0)
R
R.S.
Great tool

Great leveling tool !!!!!!!

J
J.J.
Good tool

Very handy.

K
K.S.
Works Great

Works great. Nice that you don't have to take anything apart to use it.

S
S.C.
Great service from HD as always!

Leveler saves time and is precise.

J
J.V.

I did like the design of this, as you don't have to take off the head unit. However, as noted below, be careful, as if you put tool between the swash, then power up FBL in order to setup heli, it could very well, try to crush the tool, and break your servos.
That being said, this tool worked excellent for me(IKON FBL)!

I started in the FBL software by first, adjusting the subtrims to raise the swash higher than needed to insert the tool. Insert the tool, then slowly trim each servo down until the swash just starts to touch the tool. From there, the swash is level, remove the tool, and trim all 3 servos up the exact same amount to get 0 degrees of pitch at center stick.

J
J.H.

This swash leveler has very limited value. It is designed to be installed below the swash to attain a "perfectly" leveled swash at 0° (mid-stick) collective pitch. It will not help to level the swash at high or low stick. If you don't have the servos close to 90° with sub-trim prior to installing this swash leveler, you risk permanently damaging the cyclic servos.

J
J.H.

This swash leveler has very limited value. It is designed to be installed below the swash to attain a "perfectly" leveled swash at 0° (mid-stick) collective pitch. It will not help to level the swash at high or low stick. If you don't have the servos close to 90° with sub-trim prior to installing this swash leveler, you risk permanently damaging the cyclic servos.

J
J.H.

This swash leveler has very limited value. It is designed to be installed below the swash to attain a "perfectly" leveled swash at 0° (mid-stick) collective pitch. It will not help to level the swash at high or low stick. If you don't have the servos close to 90° with sub-trim prior to installing this swash leveler, you risk permanently damaging the cyclic servos.