Free Super Saver Shipping Eligible Learn More

ALIGN Aileron Carbon Fiber Linkage Rod Set H70068 - TREX 700E

0 0
SKU: H70068
You will earn 8 points for buying this product

Availability: In Stock

As low as $0.74/mo with Affirm Learn More
Write a review earn 100 points



Illustration 1:Mix thoroughly suitable amount of epoxy. Illustration 2:Apply generous amount of epoxy on the tips of carbon tube after sliding over the linkage rod.
(Note: for quick drying epoxy, work fast as it must be applied prior to curing)
Illustration 3:Slide the carbon end caps on both sides of the carbon tube. Illustration 4:Thread the ball links onto the linkage rod until the base to base length is 97.5mm.
Illustration 5:If gap exists between the ball link and end caps after correct length has been achieved, slide the end caps outwards to cover the gaps (note: must be done before epoxy cures) Illustration 6:Wipe away excess epoxy and set it aside to cure.
Illustration 7:Pop the finished link back between aileron servo horn and bell crank.
Instruction: Specification:
Use for T-REX 700E. 700E Linkage x 4(2x110mm)
700E Aileron Control rod Carbon Fiber Shaft x 8(4x5.4x6.5mm)
700E Aileron Control rod Carbon Fiber Tube x 4(2.2x3.9x96mm)
700N Ball Link x 8(5x20.5mm)