Tron Nut Wrench For Tail Shaft Assembly - 5.5 Gemini/Orion / 7.0 Elite / 5.8 / Dnamic / Nitron / Nitron90

you will need these for most tron helis

THESE TOOLS WORK GREAT

I thought I needed it because I wasn’t sure my tools on hand would fit into the grips, but turns out they did. But the good thing is, the next time I need to do work on the tail grips I’ll have the custom made tool!

These nut drivers are optimized for the M3 size nuts on the Tron 5.8/Nitron/Dnamic tail blade grips. The outer diameter of the drivers are relatively thin at 8.72mm, so they will fit within these tail blade grips just fine. The driver end is shallow, so the M3 nut will remain close to the tip.